This page describes the control panel messages for the Hercules S/370, ESA/390, and z/Architecture emulator.
HHCPN001I Control panel thread started: tid=threadid, pid=processid
threadid, and its process id is
HHCPN002S Cannot obtain keyboard buffer: error
HHCPN003S Cannot obtain message buffer: error
HHCPN004E select: error
HHCPN005E keyboard read: error
HHCPN006E message pipe read: error
HHCPN007E RC file filename open failed: error
filename, could not be opened. The error is described by
HHCPN008I RC file processing thread started using file filename
HHCPN009E RC file buffer malloc failed: error
HHCPN010W Ignoring invalid RC file pause statement: argument
argument, on the pause statement in the startup command file is invalid. It must be a decimal number between 0 and 999. Processing will continue without any pause.
HHCPN011I Pausing RC file processing for delay seconds...
delayseconds because of a
pausestatement in the file.
HHCPN012I Resuming RC file processing...
HHCPN013I EOF reached on RC file. Processing complete.
HHCPN014E I/O error reading RC file: error
error. Any remaining commands in the file will not be processed.
HHCPN052E Target CPU nnnn type cputype does not allow ipl
nnnnis a processor engine of type
cputypewhich does not support the initial program load procedure.
HHCPN180E 'sh' commands are disabled
HHCPN181E Device number s:CCUU not found
CCUUon Logical Channel Subsystem
swas not found in the configuration.
If you have a question about Hercules, see the Hercules Frequently-Asked Questions page.
Last updated $Date: 2008-11-25 17:00:11 -0600 (Tue, 25 Nov 2008) $ $Revision: 4920 $